Directed-audio XTR5002 User Manual download pdf (Page 5)

1 2

+BAT -1. connect this terminal through a FUSE or CIRCUIT BREAKER

to the positive terminal of the vehicle battery or the positive ter-

minal of an isolated audio system battery

WARNING: Always protect this power wire by installing a fuse or

circuit breaker of the appropriate size within 12 inches of the battery

terminal connection.

REM2. - this terminal turns on the amplifier when (+) 12 volt is

applied. Connect it to the remote turn on lead of the head unit

or signal source. If a (+) 12 volt remote turn lead is not available,

a Remote Power Adapter (P/N #ORRPA) can be used to supply a

remote turn on signal. DO NOT connect this terminal to constant

(+) 12 volt

GND -3. power return connection. Connect this terminal directly

to the sheet metal chassis of the vehicle, using the shortest wire

necessary to make this connection. Always use wire of the same

gauge or larger than the (+) 12 volt power wire. The chassis con-

nection point should be scraped free of paint and dirt. Use only

quality crimped and/or soldered connectors at both ends of this

wire. DO NOT connect this terminal directly to the vehicle battery

ground terminal or any other factory ground points

CEA SPECIFICATIONS

XTR2502

Power Output: 70 Watts RMS x 2 at 4 ohms and

< 1% THD+N

Signal to Noise Ratio: >80 dBA (reference 1 Watt

into 4 ohms)

Additional Power: 140 Watts RMS x 2 at 2 ohm

and < 1% THD+N

XTR5002

Power Output: 150 Watts RMS x 2 at 4 ohms and

< 1% THD+N

Signal to Noise Ratio: >80 dBA (reference 1 Watt

into 4 ohms)

Additional Power: 300 Watts RMS x 2 at 2 ohm

and < 1% THD+N

Figure 3, Figura 3

Abbildung 3

1 2 3 4 5 6 7 8 9 10 ... 99 100

No comments

Directed-audio XTR5002 User Manual Page 5